PowerTec PT3200i, Руководство по эксплуатации

Страница: 17 / 40

17.
PT3200i
3000W DIGITAL
INVERTER GENERATOR
www.powertec.net.nz
ADDING/CHECKING ENGINE
FLUIDS AND FUEL
BEFORE ADDING/CHECKING ENGINE
FLUIDS AND FUEL, REVIEW SAFETY
SECTION
DANGER
Filling the fuel tank with gasoline while
the is running can cause
gasoline to leak and come in contact
with hot that can ignite the
gasoline.
Before the always check the level of:
• Engine oil
• Gasoline in the fuel tank
Once the is and the engine gets warm,
it is not safe to add gasoline to the fuel tank or engine
oil to the engine while the engine is running or the en
gine and are hot.
CHECKING AND / OR ADDING ENGINE OIL
Internal pressure can build in the
engine crankcase while the engine
is running. Removing the oil fill plug/
dipstick while the engine is hot can
cause extremely hot oil to spray out of
the crankcase and can severely
burn skin. Allow engine oil to cool for
several minutes before removing the
oil fill plug/dipstick.
The unit as shipped does not contain oil in the engine.
You must add engine oil before the
for the first time. See I Oil for instructions on
checking engine oil level and the procedure for
adding engine oil.
NOTICE
The engine does not contain engine oil as shipped.
Attempting to the engine without adding
engine oil will permanently damage internal engine
components.
The engine is equipped with a low oil shutdown
switch. If the oil level becomes low, the engine may
shut down and not until the oil is filled to the
proper level.
The owner of the
is responsible to ensure the
proper oil level is maintained during the operation of
the generator. Failure to maintain the proper oil level
can result in engine damage.
ADDING GASOLINE TO THE FUEL TANK
Never refuel the while the
engine is running.
Always turn the engine off and allow
the to cool before refueling.
CAUTION
Avoid prolonged skin contact with
gasoline. prolonged breathing of
gasoline vapors.
Required Gasoline - Only use gasoline that meets the
following requirements:
• Unleaded gasoline only
• Gasoline with maximum 10% ethanol added
• Gasoline with an 87 octane rating or higher
Filling the Fuel Tank - Follow the steps below to fill the
fuel tank:
1. Shut off the
2. Allow the to cool down so all surface areas
of the muffler and engine are cool to the touch.
3. Move the to a flat surface.
4. Clean area around the fuel cap.
5. Remove the fuel cap by rotating counterclockwise.
Do not the fuel tank. Spilled fuel will damage
some plastic
6. Slowly add gasoline into the fuel tank. Be very care
ful not to the tank. The gasoline level should
NOT be higher than the red ring (see Figure 5).
7. Install the fuel cap by rotating clockwise.
5: Maximum Level
WARNING
WARNING