BASIC SANDING OPERATION
NOTE: This tool is designed for sanding wood and wood
products only.
• Use the desired sanding sleeve and drum for the par-
ticular application. Choose the size that is similar to the
contour of your workpiece.
Failure to use the correct size table insert with its
matching sanding sleeve could result in injuries to fingers
or the workpiece being pulled down between the table
insert and sanding sleeve.
For best results, start with a coarse grit and sand until the
surface is uniform. Medium grit may then be used to
remove scratches from by the coarser grit and finer grit
used for the final finishing.
DUST COLLECTION
Refer to Figure 9.
A dust collection port has been provided; it is located
beneath the work table on the rear side of the sander.
The dust port is sized to fit many commomly used
wet/dry vacuums.
The use of dust collection is highly recommended.
Sawdust buildup beneath the table may prevent the
spindle from oscillating completely, causing damage to the
tool.
7
OPERATION
7
Figure 9 - Location of Dust Port
WARNING
Dust Port
