LOCKING CUTTING HEAD IN DOWN
POSITION
•
Push the switch handle down to the lowest position
•
Pull the hold-down lock out of the short slot. Rotate 90°
to the lock position in the long slot.
INSTALLATION OF DUST BAG
Refer to Figure 6
•
Squeeze the wire located at the end of dust bag.
•
Place the dust bag opening onto the dust port and
release the wire securing the dust bag onto the dust
port.
INSTALLATION OF THE HOLD-DOWN CLAMP
ASSEMBLY
Refer to Figure 7
•
Loosen the lock knob from the rear side of the saw
base.
•
Place the hold-down clamp assembly in one of the
mounting holes.
•
Tighten the lock knob.
REMOVAL AND INSTALLATION OF THE
BLADE
Turn the switch to OFF position and disconnect the
machine from power source.
REMOVING BLADES
Refer to Figure 8, 9 and 10
•
Raise the cutting head to the upright position.
•
Raise the lower blade guard to the up position.
•
Loosen the cover plate screw using a Phillips or straight
screwdriver.
•
Rotate the cover plate counterclockwise so the arbor
bolt is exposed.
•
Press and hold the arbor lock.
•
Use the large hex wrench to remove the arbor bolt by
turning wrench clockwise.
•
Remove the arbor bolt, outer washer and the blade.
Inner washer does not need to be removed.
WARNING
4
ASSEMBL
Y
Figure 7
Figure 6
Figure 8
Dust Bag
Wire
Port
Hold down clamp
Mounting holes
Blade guard
Plate screw
Cover plate
Arbor bolt
Figure 5
Hold down lock
Slot
Switch handle
Short slot
Long slot
Trigger Switch
