PowerTec HP1005, Руководство пользователя

Страница: 8 / 16

CHAMFERING
Refer to Figure 7
To make a chamfered cut, align the “V” grooves in the
front shoe of the planer with the corner edge of the
workpiece.
• Adjust to desired depth of cut.
• Place the “V” groove on the front adjustable shoe over
the edge being beveled. Place weight on the depth
adjustment knob so that the “V” groove is flat on the
edge to be beveled.
• Grasp the tool firmly with both hands. Turn the tool on
and push the plane forward with steady pressure on the
front adjustable shoe.
45°
Figure 7
Depth
Adjustment
Knob
"V" Groove
OPERATION
6
Otherwise, the resulting imbalance can cause vibration
and poor planing action while shortening the life of the
blade and the tool.
The planer blades are reversible. When one of the
cutting edges becomes dull or chipped the blade can be
reversed. When both cutting edges have been used the
blades should be discarded.
Do not attempt to sharpen or use resharpened blades of
any kind. Use only blades designated for use with this
model, as other blades may not clamp securely in blade
holder, causing vibration and a decrease in performance.
• Use the wrench supplied to loosen all clamping screws.
Figure 8
Clamping
Screws
• Clean chips and foreign matter from the cutter drum and
blade.
• If one blade edge is dull, reverse the blade. If both blade
edges are dull, remove the blade and replace it with a
new blade.
• Slide the good blade face up into the blade holder of the
cutter drum until it stops. The ridge along the blade goes
on the opposite side of the clamping screws.
Align Blade
• Loosely tighten the two outside clamping screws, the
blade must be adjusted to align with the outside edge
of the front and rear shoes.
MAINTENANCE
6
MAINTENANCE
6
WARNING
Any attempt to repair or replace electrical parts on this
tool may be hazardous. Repairs not listed here should be
performed by a qualified service technician.
WARNING
Always turn switch OFF, remove the plug from the power
source outlet and wait until the blades have come to a
complete standstill before making any adjustments or
removing or installing accessories.
• Replace any damaged or missing parts. Use parts list
to order parts. Any attempt to repair motor may create
a hazard unless repair is done by a qualified service
technician. Call the customer service line at
847-780-6120
for assistance.
REMOVING OR INSTALLING PLANER
BLADES
Refer to Figure 8–9
WARNING
Turn switch OFF, remove the plug from the power source
outlet and wait until the blades have come to a complete
standstill before making any adjustments or removing or
installing accessories.
WARNING
These blades cannot and should not be resharpened.
WARNING
The planer blades are sharp and fragile and must be
handled carefully to avoid injury to the user and damage
to the blades.
NOTICE:
Always change both blades at the same
time. Use blades of the same dimensions and weight.