PowerTec AF1045, Руководство пользователя

Страница: 5 / 16

INSTALLATION
Refer to Figure 1 to 8
This air filtration system is specifically designed to circulate
and filter non-metallic dust, which is generated throughout
the work area. The unit can be located on a work bench,
hung from an overhead support or mounted to the ceiling
or wall. When selecting a location ensure the power
source is easy to access. Ensure the remote control is
within 65 feet of the control panel with no obstructions.
IMPORTANT : When determining a location for the air
filtration system, always select a location where the air
flow is unrestricted. Locate the unit away from corners and
any heating or cooling vents.
CAUTION
The air filtration system is too heavy to be lifted by one
person. Obtain assistance from others before trying to lift
or move.
Remove the Shipping Blocks
Refer to Figures 2 -3
Styrofoam shipping blocks are installed around the motor
to prevent damage during shipping. These MUST be
removed before operation.
• Lift up on the clips located at the top and bottom of the
cabinet and remove the outer filter.
• Pull the inner filter from the cabinet.
• Remove the four Phillips head screws securing the inner
grate and remove the inner grate.
• Remove the shipping blocks and replace the inner grate.
Figure 2
Inner Grate
Screws Screws
Figure 3
Shipping
Block
Shipping
Block
ASSEMBLY
3
• Follow the instructions under
Changing the Filters
to
replace the filters correctly.
Work Bench Location
Tools required for assembly:
None
CAUTION
Clamp the air filtration system in place if using on a work
bench or sawhorse, if not permanently mounting the unit.
• With assistance, carefully turn the air filtration
system over.
• Use the double sided tape to attach the four rubber feet
to the four bottom corners of the unit. (Figure 4)
• With assistance, carefully turn the air filtration
system over.
• Place the air filtration system onto a work bench, ensure
the air flow is not restricted and the unit is away from
corners and any heating or cooling vents.
• Plug the power cord into the correct receptacle.
(Refer to
Power Source
paragraph in this section of
the manual.)
Figure 4
Rubber Feet
Rubber Feet