WARNING
To prevent kickback make sure the featherboard is at
least 1" (2.5 cm) from the saw blade.
WARNING
ALWAYS use the power tool with all guards in place.
For clarity the saw blade guard is not shown in
the illustrations.
SUGGESTED MOUNTING APPLICATIONS
The
Powertec 71469 Fence Featherboard 1 Pack
can
be mounted horizontally in a standard 3/4" miter slot or
vertically in a T-slotted fence.
These are a few suggested mounting applications:
• The featherboard mounted horizontal in a miter slot
or vertical in a T-slotted fence, see
Assemble to a
T-Slotted Fence
for instructions.
• The featherboard mounted horizontally in a miter slot,
see
Assemble to a Table Top
for instructions.
• Two 71469 Fence Featherboard 1 packs are needed for
this application - Two featherboards double stacked and
mounted horizontally in a miter slot, see
Assemble to a
Table Top
for instructions.
The
Powertec 71553 Fence Featherboard 2 Pack
can
be mounted horizontally in a standard 3/4" miter slot or
vertically in a T-slotted fence.
These are a few suggested mounting applications:
• One featherboard mounted horizontal in a miter slot and
one featherboard mounted vertical in a T-slotted fence,
see
Assemble to a T-Slotted Fence
for instructions.
• One or two featherboards mounted horizontally
in a miter slot, see
Assemble to a Table Top
for instructions.
• Two featherboards double stacked and mounted
horizontally in a miter slot, see
Assemble to a Table
Top
for instructions.
ASSEMBLE TO T-SLOTTED FENCE
Refer to Figure 2
NOTE:
Fits most T-slotted fences
NOTE:
In this application the featherboards may be used
single or double stacked.
• Insert a 5/16"-18 x 2-1/2" long T-Bolt through the slot
in the featherboard, a 5/16" washer and secure with
locking knob. Do not tighten. Repeat on other side.
NOTE:
If double stacking the featherboards use the
spacer in between the featherboards.
• Slide the T-Bolt into the desired slot on the T-Slotted
Fence, position the featherboard(s) and tighten
locking knobs.
Miter Slot in Table
T-Slotted
Fence
Figure 2
Single Stack Fence Featherboard for
vertical and horizontal support
Locking
Knob
Slot Bracket
Screw, 5/16"-18 x 2"
5/16" Washer
Locking
Knob
5/16" Washer
T-Bolt,
5/16"-18 x 2-1/2"
ASSEMBLE TO A TABLE TOP
Refer to Figure 3, 4
NOTE:
Fits most table tops with a 3/4" miter slot.
NOTE:
Mount a single featherboard for standard flat work
or double stack the featherboards to support the workpiece
higher up on the fence.
Single Featherboards
• Insert a 5/16"-18 x 2" long screw through the bottom of
the slot bracket, the slot in featherboard, a 5/16" washer
and secure with a locking knob. Do not tighten. Repeat
on other side.
• Slide the slot brackets into the miter slot on the
table top, position the featherboard and tighten with
locking knobs.
Fence
Saw Blade
Figure 3
Slot Bracket
Locking
Knob
Screw,
5/16"-18 x 2"
5/16" Washer
Miter Slot in Table
