* PORTER-CABLE, D
e
WALT, Elu and Craftsman are trademarks of The Black &
Decker Corporation/ Bosch is a trademark of the Robert Bosch Tool Corporation/
Milwaukee is a trademark of Milwaukee Electric Tool Corporation/ Makita is a
trademark of Makita Corporation/ Fein is a trademark of C. & E. Fein GmbH/ Hitachi
is a trademark of Hitachi, Ltd./ Ryobi is a trademark of RYOBI, LTD.
Southern Technologies, LLC
Waukegan, IL 60087
Put these instructions and the original sales invoice in a safe,
dry place for future reference.
Visit us on the web at
powertecproducts.com
• The radius of the circle will be the distance from the
inside edge of the router bit to the center of the pin.
Figure 3 shows the side view of the circle cutting jig
setup to make a 24" (610 mm) circle with a 1/2" bit.
Figure 3
12" (305 mm)
12" (305 mm)
12" (305 mm)
• Set the router depth of cut and route in a
counterclockwise direction as shown in Figure 4.
Figure 4
12" (305 mm)
12" (305 mm)
MAINTENANCE
• Carnauba wax may be applied to the circle cutting jig to
reduce scratching and make it slide easier. If scratching
does occur, carefully polish with plastic polish until the
scratches are removed.
18-0928