Powersmart PSS1210LED, Инструкция по эксплуатации

Страница: 11 / 65

11
• Some parts of your Snow Thrower may freeze under extreme temperature conditions. Do not
attempt to operate your Snow Thrower with frozen parts. If the parts freeze while your Snow
Thrower is in use, stop your Snow Thrower and inspect it for frozen parts. Thaw all parts before
restarting and operating your Snow Thrower. Never force parts or controls that have frozen.
Never use an open flame of any sort to thaw frozen parts.
Pre-Operation Inspection - IMPORTANT!!!
Before using your Snow Thrower for the first time, check the following:
•
Have you read and followed all setup and operation procedures for the engine as outlined in
the ENGINE manual?
• Has the engine been filled with oil and gasoline to the proper level?
• Are all snow thrower components properly attached and assembled?
• Are there any broken or damaged parts?
• Are all fasteners tight?
• Are the tires inflated to the proper pressure?
NOTICE: If you are unsure about the assembly or condition of any of your Snow Thrower parts,
please call our customer service department at (800)791 9458.
STARTING
MANUAL START THE ENGINE
1.Move the choke lever to START position (Right side).
2.Press the primer bulb 3 times.
3.Insert switch key into slot (Do not turn switch key).
4.Pull on the recoil starter handle slowly until a slight resistance is
felt, then pull quickly to start the engine. Return cord gently into the
recoil starter. Never allow the cord to snap back.
5.If engine fails to start, repeat step 4. NOTE: After repeated failed
attempts to start the engine, please consult the troubleshooting guide
before attempting again. If problems persist, please call customer
service at (800)791 9458.
6.Once the engine has started, slowly return the choke lever all the
way to the “OPEN” position (Left side).
7.Allow the engine to run for several minutes before using snow thrower.
ELECTRIC START THE ENGINE
1.Move the choke lever to START position (Right side).
2.Press the primer bulb 3 times.
3.Insert switch key into slot (Do not turn switch key).
4.Plug the power cord to starting motor.
5.Press the start button for 2-3 seconds or until the engine starts. NOTE: If the engine does
not start after 2-3 seconds, release the start button.
6.If engine fails to start, repeat step 5. NOTE: After repeated failed attempts to start the
engine, please consult the troubleshooting guide before attempting again. If problems persist,
please call customer service at (800)791 9458.
7.Once the engine has started, slowly return the choke lever all the way to the “OPEN”
position (Left side).
8.Allow the engine to run for several minutes before using snow thrower.