Powersmart PS76120A, Инструкция по эксплуатации

Страница: 17 / 24

17
GUIDE BAR MAINTENANCE
When the guide bar shows signs of wear, reverse it on the saw to distribute the wear for maximum bar life.
The bar should be cleaned every day of use and checked for wear and damage.
Feathering or burring of the bar rails is a normal process of bar wear. Such faults should be smoothed
with a file as soon as they occur.
A bar with any of the following faults should be replaced.
Wear inside the bar rails which permits the chain to lay over sideways.
Bent guide bar.
Cracked or broken rails.
Spread rails.
Lubricate guide bars with a sprocket at their tip weekly. Using a grease syringe, lubricate weekly in the
lubricating hole. Turn the guide bar and check that the lubrication holes and chain groove are free from
impurities.
BATTERY PACK
• Store the battery pack fully charged.
• Once the charging light turns green, remove the battery from the charger and disconnect the charger
from the outlet.
• Do not store the battery pack on the tool.
• After charging, the battery pack may be stored in the charger, as long as the charger is not plugged in.
CHARGER MAINTENANCE
• Keep the charger clean and clear of debris. Do not allow foreign material to get into the recessed
cavity or onto the contacts. Wipe the charger clean with a dry cloth. Do not use solvents or water, and
do not place the charger in wet conditions.
• Unplug the charger when there is no battery pack in it.
• Fully charge the batteries before placing them in storage.
• Store the charger at normal room temperature. Do not store it in excessive heat. Do not use the
charger in direct sunlight. Recharge at room temperature between 45˚F and 104˚F . If the battery
pack is hot, allow it to cool down before recharging.
STORAGE
• Store out of the reach of children.
• Clean all foreign material from the product. Store idle unit indoors in a dry, well-ventilated area that
is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing
salts.