CONNECTION DIAGRAM
Caution! Voltage of heating elements 220-240V
Caution! In the event of any connection the safety
wire must be connected to the
PE terminal.
Recommended
type of
connection
lead
N
L
PE
Fig. 9
GAS CONNECTION (RGI qualified personnel only)
The appliance has an G 1/2" threaded pipe connector to connect it to the gas
system. Please ensure that the connection is made using a rigid pipe.
When making the gas connection, it is important to place the gasket (A) in
between the inlet pipe (C) and the elbow (B) to ensure a tight gas seal (Fig. 8).
ELECTRICAL CONNECTION
The appliance must be connected to the mains supply by a qualified gas
engineer using fixed wiring via a double pole switched fused spur outlet protected by a 3A fuse and with
a contact separation of at least 3mm in all poles. We recommend that the appliance is connected by a
qualified electrician who is a member of the N.I.C.E.I.C. and will comply with I.E.T. and local regulations.
The wires in the mains lead are coloured in accordance with the following code: Green & Yellow =
Earth, Blue = Neutral, Brown = Live.
A
B
C
D
M
NATURAL GAS TO LPG CONVERSION
This conversion must only be carried out by a competent person (i.e. a Gas Safe registered fitter).
Instructions to fit replacement injectors:
1. Disconnect the appliance from the gas and electrical supplies.
2. Remove burner components “B” and pan supports (Fig. 9).
3. Remove the injectors “A” (Fig. 9) with a socket spanner and replace with the corresponding injectors.
Setting up minimum flow rates:
1. Turn on the LPG supply, light the burners and turn the controls to the minimum position as indicated
by the small flame symbol.
2. Remove the control knobs “M” (Fig. 10).
3. Insert a small screwdriver “D” (Fig. 10) into the hole at the top of the tap “C” and turn the adjustment
screw left or right until the flame of the burner is conveniently regulated to the low position.
4. Make sure when turning quickly from maximun position to minimum position that the flame does not
extinguish.
5. Replace the knobs “M”.
Fig. 8
B
A
C
N
L
Fig. 10
4
1
1
2
2
2
3
4
2
5
