POWXQ5107
EN
Copyright © 2015 VARO NV
P a g e
|
9
www.varo.com
Never use a cutting disc for grinding/roughing!
9.3
Cutting
When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane.
The cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard stone.
It is prohibited to use the machine on asbestos materials!
Never use a grinding disc for cutting!
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power plug.
10.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2
Lubrication
The machine does not need any extra lubrication.
10.3
mains cable & plug
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
Mains voltage / Mains frequency
230-240 V / 50 Hz
Rated Power:
2450W
No load speed
6000 min-1
Max. disc diameter:
230mm
Drive spindle thread:
M 14
Weight (+/-):
5.98 Kg
Insulation class :
/ class II Double insulated
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
98 dB(A)
Acoustic power level LwA
109 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration) :
7.1 m/s²
K = 1.5 m/s²