POWX221
EN
Copyright © 2017 VARO
P a g e
|
11
www.varo.com
9.2
Lubrication
The machine requires no additional lubrication.
10 TROUBLE SHOOTING
In the case that the machine is not functioning properly, we give a number of possible causes
and appropriate solutions below.
1. The engine does not start
The plug is not in the mains.
The cable has been interrupted.
2. The workpieces is jamming against
the riving knife during processing
The saw blade must be aligned (Fig. E).
3. The saw cut is not smooth (frayed)
The saw blade must be sharpened.
The saw blade has been assembled back-to
front.
The saw blade has become coated with resin or
sawdust.
The saw blade is not suitable for this process.
4. The workpiece is touching the back
of the saw blade and is jumping out.
The riving knife must be aligned (Fig. E).
The fence is not being used.
The saw blade is thicker than the riving knife or
the riving knife is not being used
The saw blade must be sharpened.
The workpiece has not been kept in its place
until after sawing.
The tension button of the cross-cut fence is
loose.
5. The height and/or mitre handle is
blocked
Sawdust and dust must be removed.
6. The engine has difficulty reaching
the maximum number of revolutions.
The extension cable is too thin and/or too long.
The mains voltage is lower than 230 V.
7. The machine is vibrating.
The machine has not been fastened onto the
workbench.
The frame is not level with the floor.
The saw blade has been damaged.
11 TECHNICAL DATA
Voltage / Frequency
230-240 V~ / 50 Hz
Power input
1500 W
No load speed
4500 min-1
Saw blade dimensions
Ø 254x Ø 30x 2.8mm
Number of teeth
40
Measurements of bench
638 x 430 mm
Dust extraction outlet
Ø 40(35) mm
Weight
30 kg
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
99 dB(A)
Acoustic power level LwA
112 dB(A)
ATTENTION!
Wear
hearing
protection
when
sound
pressure
is
over 85 dB(A).
