POWX131
EN
Copyright © 2015 VARO
P a g e
|
7
www.varo.com
Never use the spindle lock to stop the motor.
9.2
Marking the workpiece s.
Before starling with the biscuit jointer the work pieces must be marked as following:
Place the two work pieces. Which must be connected, on top of each other.
Fasten the work pieces and mark the center of the groove.
The space between two grooves should be 10-15cm. This is not applicable for smaller
Work pieces- smaller work pieces don't have to be marked
9.3
Positioning of the machine
Based on the size of the work pieces the machine can be positioned in several ways.
9.4
Large wqpkpieces:
Place the machine near the work piece
The middle of the base plate (this point is marked on the base plate) must face the center
of the groove in the work piece, {see marking the work piece).
9.5
Small workpieces.
Place the machine near the work piece
The side of the machine must be lacing the side of the work piece.
9.6
Sawing grooves
Move the motor base backward.
Place the machine near the work piece.
Position the machine (see positioning of the machine)
Hold the machine with both hands and switch the machine on.
Push the motor base carefully forward as far as possible.
Move the motor base backward and switch the machine off.
9.7
Joining the workpieces
When the grooves in both work pieces have been made the workplaces can be joined together
Put glue in both grooves.
Race the biscuit dowel in the groove of one work piece.
Place the other work piece on the biscuit dowel.
Fasten the work pieces and wait till the glue is dry.
9.8
Checking the cutting depth
Always check the cutting depth after mounting a saw blade.
Disconnect the plug from the socket.
Move the motor base (14} as far as possible backwards.
Set the cutting depth in the maximum position by turning the depth adjustment knob (6).
Move the motor base forwards till the pin will fall in the notch of the adjustment knob (6)
Turn the saw blade till one tooth of the saw blade is in the front position.
Measure the distance from the side of the base plate to the tooth of the saw blade.
Check if the distance is 19mm. The maximum position is 18mm.
9.9
Setting the cutting depth
When the cutting depth is not correct, II can be adjusted as following:
Move the motor base (14) as far as possible backwards
Loosen the Pin
Sell the cutting depth by luring the screw, the screw is positioned at the back of the pin.
Repeat the procedure till the cutting depth is correct.
Fasten the Pin.
