POWX1196
EN
Copyright © 2020 VARO NV
P a g e
|
8
www.varo.com
▪
Turn the function selector switch (1) to the chisel position adjustment
▪
Turn the tool in the tool holder (8) to the required position
▪
Turn the function selector (1) to the chiselling for the chiselling function
8.3
Preselecting the rotation speed
▪
You can use the rotational speed preslector dial (6) to preselect the rotational speed: level
1 (low rotation speed) up to level 6 (high rotation speed).
▪
Work-out the correct setting by carrying out a test
i. Level 1-3: low speed for drilling in steel or wood
ii. Level 3-6: high speed for hammer drilling/chiselling in concrete
or stone
8.4
LED display
▪
The green led (5) lights up when the mains plug is inserted
▪
The red led (4) light up when the carbon brushes are worn down. Stop all work and the
appliance to the customer service
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use a chuck with SDS connector in combination with the
hammer/hammer drill function!
8.5
How to use the demolition hammer
1.
After placing the tip of the tool on concrete surface, switch ON (3).
2.
By utilizing the weight of the machine and by firmly holding the demolition hammer with
both hands, one can effectively control the subsequent recoil motion.
3.
Proceed at a moderate work-rate, the use of too much force will impair efficiency.
CAUTION After long time of use, the cylinder case becomes hot. Therefore,
be careful not to burn your hands.
WARNING Don’t apply big pressure to the machine. The hammer mechanism
is activated by applying a slight pressure on the tool when the chisel bit is in
contact with the work-piece.
9 LUBRICATION - OIL LEVEL
▪
Before fitting a tool into the holder (8), grease it lightly.
Important: The waste oil must be disposed of in the appropriate collection
point for waste oil.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
