POWX093
EN
Copyright © 2015 VARO
P a g e
|
9
www.varo.com
7.7
Profile accessories
The accessories can be used for work on profiled workpieces such as the head of a bed and if
you wish to repeat the outside profile further towards the inside. Take the parallel guide.
Loosen and remove the four cros>head screws attaching the plastic guides (16). Remove the
plastic guides and keep them in a safe place for further use. Locate the profile accessories
and position this casting (17). Secure it with two cross-head screws. Push the parallel guide
into the machine base. Select the right cutter head for this job. Position the workpiece carefully
and begin cutting (18).
7.8
Circle cutting accessories
Accessories for cutting
circles are also supplied. These allow you to cut perfect circles in
workpieces. Attach one of the parallel guide rods in the machine
base (19). Mount the circle-cutting accessory at the other end. You
can attach this accessory to any position on the guide rod. Position
the tip of the circle-cutting accessory at the centre of your circle.
Press it slightly so that the tip is firmly in the wood. You can now
cut the circle.
7.9
Setting the working depth
To set the cutting depth, release the plunger locking lever and press the cutter downwards
until the desired depth is reached. Then re-lock the lever (Locking lever for cutting machine
body). To set the cutter to a fixed depth, set the depth stop (20) and secure it with the knob
(21).
7.10
Fine adjustment
When the approximate depth is set, you can make fine adjustments
by means of the fine-adjustment knob {22). To adjust, turn it in
clockwise or anticlockwise direction.
7.11
Cutting in serval operations
For cutting in depth and in stages, use the length-stop turret as
an aid. Using the depth scale, set the desired depth to the
lowest depth-stop position on the turret. Rotate the turret so that
the highest point is under the depth stop and execute the first
cut (23). Repeat the cut with the second-highest
setting and finally with the last setting. You can also use two
positions if the desired depth is reached in two operations..
