Powerplus POWX07573T, Руководство пользователя

Страница: 9 / 13

POWX07573T
EN
Copyright © 2016 VARO
P a g e | 9
www.varo.com
9.8 Depth stop (Fig. 3)
When not a complete cut through the work piece is desired, use the depth stop bolt to control
the depth of cut.
Only adjust the front bolt. The rear bolt is used to prevent the blade from
cutting the table during normal cutting. Do not adjust the rear bolt.

Unlock the retaining pin.

Raise the saw head assembly.

Push the depth stop to the left to use the depth stop bolt settings.

Pull down on the saw head to check the current setting.

To change the setting, first loosen the knurled depth stop nut on the depth stop bolt. Turn
the depth stop bolt clockwise to decrease depth and counterclockwise to increase depth.
Tighten the depth stop nut after adjustment.

If needed, push the depth stop to the right to temporarily disable it.
9.9 Switching ON / OFF
For your safety use both hands to switch the power tool on and off.

Connect the power tool to the power supply.

Pull the on/off switch (16) in the direction of the handle. The saw blade rotates as long as
you keep the switch engaged.

When you want to turn off the machine, you have to release the on/off switch (16).

To turn the machine on, simultaneously press the main switch (16) and locking button
(27).

Important! Place the material you want to saw flat on the machine surface and secure with
the clamping device (12) so that the material cannot move while you are cutting.

After switching on the saw, wait for the blade (2) to reach its maximum speed.

Press the release lever (17) sideways and, using the handle (18), apply steady and light
downward pressure to move the machine head through the workpiece.

When the cut is completed, return the machine to its top parking position and let go of the
On/Off switch.
Caution! A return spring causes the machine head to rise automatically at the end of the cut.
Do not let go of the handle (18) as soon as the cut is completed but steady the machine head
and allow it to rise slowly.
9.10 Laser (13)
Your machine is equipped with a laser.
The laser helps you to cut the work pieces at the correct place.
9.11 Dust bag
To attach the dust bag (20), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
9.12 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.

Clamp the work piece firmly.

Set the required horizontal mitre angle or the required vertical bevel angle.