POWX075730S
EN
Copyright © 2021 VARO
P a g e
|
12
www.varo.com
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
10.2
Connecting cable
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
Nominal Voltage
220-240 V ~ 50 Hz
Power rating
2100 W (S6 25%)
No load speed
5000 min-1
Protection class
II
Blade size
254 mm x 30 mm x 2.8 mm
12 CUTTING CAPACITY
Worktable tilting
angle
Head tilting angle
Height x width (mm)
90°
90°
75 x 305 mm
45°
90°
75 x 210 mm
90°
45°
38 x 305 mm
45°
45°
38 x 210 mm
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
94 dB(A)
Acoustic power level LwA
107 dB(A)
ATTENTION!
Wear
hearing
protection
when
sound
pressure
is
over 85 dB(A).
14 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪
Don’t keep it in plastic bags to avoid humidity build-up.
15 TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Motor does not run.
No electricity arrives at the machine.
The motor is overloaded or
overheated.
Check the power supply
and the power line.
Allow the machine to run
idle for about 2 minutes to
cool down.
Vibrations are too
strong.
Screws or parts are loose.
Tighten all screws.