POWEG7010
EN
Copyright © 2017 VARO
P a g e
|
7
www.varo.com
Never pass the appliance over the extension cable that the application is working, as this
could cut the cable. Mark sure you always know where the cable is.
Use the special cable holder for the connection of the extension cable.
Never use the appliance when it is raining. Try to prevent it from getting wet or being
exposed to humidity. Do not leave it outside overnight. Do not cut damp or wet grass.
The power supply cable should be checked regularly and before using it each time, make
sure the cable is not damaged or old out. If the cable is not in good condition, do not use
the appliance; take it to an authorized service center instead.
Only use an extension cable that is suitable for outdoor work. Keep it away from the
cutting area, from damp, wet or oily surfaces or with sharp edges and away from heat and
fuels.
The mobile socket of the extension cable should be splash proof in compliance with DIN
57282 and VDE 0282 regulations; the cross-section of the wire (max. length 75 m) should
be at least 1.5 mm². Use H07RN-F harmonized cable.
7 GUIDELINES FOR USING EXTENSION CORDS
Make sure the extension cord is in good condition. When using an extension cord, be sure
to use one that is heavy enough to carry the current that your product will draw. An
undersized cord will cause a drop in line voltage, which will result in loss of power and
overheating.
Make sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord, or have it repaired by a qualified person before using it. Protect
your extension cords from sharp objects, excessive heat, and damp or wet areas.
Before connecting the motor to the power line, make sure the switch is in the OFF position
and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
This tool must be grounded while in use in order to protect the operator
from electric shock.
8 ASSEMBLY
This product must be assembled correctly before use.
1.
Insert the lower handle section to motor housing and fix it by two supplied screws M4x16.
(Fig. 1-1)
2.
Attach the center handle section to the lower handle sections using the two supplied
M6x45 bolts and wing nuts. (Fig. 1-2)
3.
Fasten the upper handle section to the center handle section using the two supplied
M6x45 bolts and wing nuts. (Fig. 1-3)
4.
Use the two supplied cable clips to secure the cord. (Fig. 1-4)
9 OPERATION
9.1
Double insulation
The tiller has double insulation. This means that all external metal parts are insulated from the
electrical supply.
This is achieved by introducing an insulation layer between electrical and mechanical parts.
The double insulation guarantees you the greatest possible safety.
9.2
Overheat protection
If the application is blocked by a foreign object or if the motor is overloaded, the motor will
switch off automatically by the protection device. Release the trigger lever and wait till the
motor cool down (approx. 15 minutes) then start application again.
