POWEG5011
EN
Copyright © 2019 VARO
P a g e
|
9
www.varo.com
8
OPERATION
8.1
On/off switch (Fig. 3)
▪
Press the on/off switch to start and/or stop the machine.
Note: the machine is equipped with a safety switch to prevent it from being switched on again
accidentally after a power failure.
8.2
Overload protection (Fig. 4)
Overload (e.g. blocking up of the cutting blades) leads to a standstill of the machine after a few
seconds. To protect the motor from being damaged, the overload switch (8) will cut the mains
automatically. Wait at least 1 minute before restarting by first pressing the reset button and
then the on/off switch.
In the event of blocking of the cutting blade, turn the rotational direction switch to the right
position before switching the shredder on again
If the motor does not restart, do the following:
▪
Remove the plug from the mains socket.
▪
Loosen the hand screw (2) and open the top part upwards.
▪
Clean carefully the cutting and discharge parts and remove any objects that could obstruct
the blades.
▪
Put the top part back and tighten the hand screw firmly.
▪
Press the reset button before pressing the On/Off switch.
Attention! Always wear safety gloves when executing the steps mentioned
above!
8.3
Safety lock
The shredder is equipped with the safety switch at the lock between the top and bottom parts.
If the top part does not fit perfectly and sit fast on the bottom part, the SAFETY SWITCH is
activated and the motor will not work. If this happens:
▪
Remove the plug from the mains socket.
▪
Remove the top part, as described in the previous paragraph.
▪
Clean carefully the cutting and discharge parts and remove any objects that could obstruct
the blades.
▪
Put them together again and tighten the hand screw firmly.
ATTENTION: Never loosen the hand screw before first turning off the On/Off
switch and removing the plug from the mains socket.
8.4
Disassembly
In certain circumstances, e.g. storage after use, you can take the machine apart by performing
the assembly steps in reverse order, as described earlier.
8.5
Instructions for use
▪
Place the material to be shredded in the opening on the right side. It will then be
automatically drawn into the machine by the cutter as it turns counter clockwise.
▪
Do not stuff the opening completely full to avoid jamming the machine.
▪
Alternate feeding branches and small litter that is a bit wet and decomposed. This will also
help to avoid jamming the cutter.
▪
Squashy kitchen rubbish must be composted, never put it through the shredder!
▪
Branches with leaves must always be entirely through the shredder and out of the way
before feeding new material into the machine. Make sure the shredded material is able to
fall unobstructed into the bag without blocking the outlet.
▪
The ventilation opening must not be blocked by the shredded material.
