POWE51101
EN
Copyright © 2019 VARO
P a g e
|
8
www.varo.com
8.2.3
Setting mechanism for the tilt angle
The saw blade can be adjusted to any angle between 0° and 45°. Loosen the locking knob (3),
press the lever (2) and turn to the desired tilt angle and tighten the locking knob (3).
8.2.4
Hand crank for setting the cutting height
The cutting height of the saw blade must be adjusted to the height of the workpiece. The saw
blade must always be set to one blade tooth higher than the workpiece. You can set this by
turning the hand crank to left or right.
Note: In order to make use of the full range of 45° settings, the cutting
height must be reduced accordingly.
8.3
Workpiece stops
8.3.1
Mitre angle stop
The stop can be adjusted by a maximum of 120 mm for mitre cutting.
Risk of injury! Do not push the stop (Fig. 4 A) too far in the direction of the
saw blade. The gap between the stop (Fig. 4 A) and the saw blade should be
approximately 2 cm.
8.3.2
Mitre cuts (Fig. 7)
▪
Push the mitre angle stop (11) into the required slot of the table surface.
▪
Loosen adjusting screw (A), set the required angle and then tighten the adjusting screw
again.
▪
If necessary, push the stop plate backwards or forwards. For this, loosen both adjusting
screws (B), push stop plate (C) and then retighten adjusting screws (B).
8.3.3
Setting the stop rail of the parallel stop
The stop rail can be removed and repositioned after both wing nuts have been loosened:
High stop edge:
▪
To saw tall workpieces.
Low stop edge:
▪
To saw flat workpieces.
▪
If the saw blade is angled.
8.3.4
Parallel stop
▪
Loosen the locking lever (10) by turning the knob.
▪
Set the parallel stop to the required cutting width by pushing on the scale.
▪
Press down the locking lever (10).
8.4
Setting the cutting height (Fig. 8)
Risk of injury! Parts of the body or objects located in the adjustment area
may be caught by the operating saw blade! Only adjust the cutting height
when the saw blade is at a standstill!
▪
Adjust the cutting depth by turning the hand crank (A).
