POW63172
EN
Copyright © 2015 VARO
P a g e
|
5
www.varo.com
Always position yourself horizontally to the slope and make sure your feet are firmly
planted. Exercise particular caution whenever you change directions while working on a
slope.
Walk at a measured pace while operating the blower. DO NOT RUN.
Never direct the suction/blown air opening toward persons or animals.
The Vac-Blower must not be used or starting until it has been fully assembled.
Make sure the power cord is kept behind and away from the device while you work.
If the power cord or extension cord are damaged while you work, unplug the blower
immediately.
Never use the power cord as a handle to lift or carry the device.
Always unplug the device under the fol lowing circumstances:
When the blower is not in use, is being carried/transported, or is left unattended.
While examining, cleaning or unclogging the device.
When cleaning the device, performing maintenance on it, or attaching accessories to it.
If the device strikes a foreign object or begins vibrating abnormally.
Use the blower in daylight or with adequate illumination.
Bear in mind that the force generated by an electrical device can make you lose your
balance. Therefore, make sure that your feet are firmly planted and that your body is well
balanced when you are operating the device.
Never operate the blower on damp or wet grass.
Using the blower on sloping areas: Do not work in areas with unduly steep slopes.
Use the blower as follows when working on slopes:
Always position yourself horizontally to the slope and make sure your feet are firmly
planted. Exercise particular caution whenever you change directions while working on a
slope.
Keep the air outlet unobstructed and clean at all times.
Never direct the suction/blown air opening toward persons or animals.
7
ASSEMBLY
Your new blower vac requires very little assembly work before it is ready for use.
7.1
Assembling the tubes (Fig 1, 2)
Screw the top tube (3) onto the motor housing.
Screw the bottom tube section (1) onto the top tube.
7.2
Shoulder strap
Attach the shoulder strap (8) to the forseen hook on the handle. To adjust the shoulder strap
to the required length, simply slide the adjustable strap buckle forward or backwards.
7.3
Leaf bag (Fig 3)
To secure the leaf bag(5) to the machine, simply attach the buckle to the top tube section
and pull the expanding bag opening over the leaf discharge point on the bottom of the motor
casing.
8
OPERATION
8.1
Steps prior to operation
Only operate the device after completely assembling it. Prior to each use, check the power
cord for signs of damage. Under no circumstances should the power cord be used if it shows
any signs of damage.
Ensure that the blower vac is only connected to conventional sockets with a 230 - 240V
alternating current supply.
8.2
Switching ON/OFF
Press the On/Off switch(9) to start machine.