POWAIR0340
EN
Copyright © 2011 VARO
P a g e
|
7
www.varo.com
SYMPTOM
PROBLEM
SOLUTIONS
Tool skips fasteners.
1. Worn bumper or damaged
spring.
2. Dirt in front plate.
3. Dirt or damage prevents
fasteners from moving freely
in magazine.
4. Worn or dry O-ring on
piston or lack of Lubrication.
5. Cylinder covers seal
leaking.
1. Replace bumper or pusher
spring.
2. Clean drive channel on
front plate.
3. Magazine needs to be
cleaned.
4. O-ring needs to be
replaced.
And lubricate.
5. Replace Sealing washer.
Tool jams.
1. Incorrect or damaged
fasteners.
2. Damaged or worn driver
guide.
3. Magazine or nose screw
loose.
4. Magazine is dirty.
1. Change and use correct
fastener.
2. Check and replace the
driver.
3. Tighten the magazine.
4. Clean the magazine.
11
ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with the
household rubbish but dispose of it in an environmentally safe way.
