POWDPG7550
EN
Copyright © 2017 VARO
P a g e
|
9
www.varo.com
8.2
Removal / insertion of battery
WARNING: Before making any adjustments ensure the tool is switched off
or remove the battery pack.
Hold the tool with one hand and the battery pack (10) with the other.
To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3
Battery capacity indicator (fig. 1)
There are battery capacity indicators (13) on the battery pack, you can check the capacity
status of the battery if you squeeze the button (14). Before using the machine, please press
switch trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1
Bike handle installation (Fig. 2)
Place handle between handle clamp and handle holder. Adjust the handle to an angle that
provides a comfortable working position and then tighten four screws(A) so that the handle
assembly cannot move.
Place grip cover the handle and grip hold (1). Adjust the handle to an angle that provides a
comfortable working position (2) and then tighten one screw (B) and one nut so that the
grip assembly cannot move.
9.2
Installation protection guard (Fig. 3)
Fit the correct trimmer guard for use with the motor
，
then tighten three screws so that the
guard assembly cannot move.
9.3
Installing the harness (Fig. 4)
Adjust the harness hanger in a comfortable position
Buckle the harness at the hanger
9.4
Replace the metal blade to spool
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped
or missing. Replace a damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and
installing a blade.
9.4.1
Metal blade (Fig. 5)
Turn the tool upside down so that you can replace the cutter blade (2) easily.
To dismount the cutter blade (2), insert the hex wrench through the hole on the protector
cover and receive washer (1). rotate the receive washer (1) until it is locked with the hex
wrench. Loosen the hex nut (5) (left-hand thread)with the hex socket wrench and remove
the nut (5), cup (4), clamp washer (3) and hex wrench.
Mount the cutter blade (2) onto the shaft so that the guide of the receive washer fits in the
arbor hole in the cutter blade . Install the clamp washer (3), cup (4), and secure the cutter
