www.powermaxfitness.net
14
ROUTINE MAINTENANCE
Warning:
Before cleaning or maintaining products, please be sure the power plug of the
treadmill is pulled out.
Cleaning:
Comprehensive cleaning will extend the using life of the electric treadmill.
Remove dust periodically in order to keep the parts clean. Be sure to clean running belt with both
sides of the exposed portion, which will reduce the accumulation of impurities. Make sure to wear
clean athletic shoes to avoid carrying the dirty matters into running board and belt. Treadmill
belts shall be cleaned by a damp cloth with soap. And please pay attention to avoid too wet the
electrical components and running belt.
Warning:
Make sure power plug disconnect before moving motor cover away, clean the motor
at least once a year.
Running Belt Specialized Lubricant
This electric treadmill’s running board and running belt has been lubricated in factory. Friction
between the running belt and running board has a great influence to the using life and the
performance of the electric treadmill, therefore regular applying of lubricant is needed. We advise
you to check the board regularly. If the board’s surface is damaged, please contac
t our customer
service centre.
We advise using lubricant between running belt and running board with following schedule:
Lightweight user (use less than 3 hours a week) once per month;
Heavyweight use (use more than 7 hours a week) once every half month.
1.
In order to better safeguard your electric treadmill and extend the life of the machine, it is
recommended that after your continued use of two hours, turn off the machine and let it rest for
10 minutes before using again.
2.
If the treadmill belt is too loose, there will be skid
phenomenon’s
while running; if it’s too
tight, it may reduce motor performance and harden the abrasion of roller and the running belt.
You can lift two sides of the running belt for 50-75mm when the tightness is appropriate.
Running Belt Alignment
⚫
Put electric treadmill flat on the ground.
⚫
Make the electric treadmill run at a speed of about 6-8km/hour.
⚫
If the running belt is closer to the right, rotate the right adjusting bolt with 1/2 turn
clockwise, then rotate the left adjusting bolt with 1/2 turn counter-clockwise. (Picture A)
⚫
If the running belt is closer to the left, rotate the left adjusting bolt with 1/2 turn clockwise,
then rotate the right adjusting bolt with 1/2 turn counter-clockwise. (Picture B)
