Powermatic 1794860K, Инструкция по эксплуатации и каталог запасных частей

Страница: 14 / 28

14
Vertical play at the outer rail has now been
corrected. To eliminate vertical play at the inner rail:
11. Slide table forward and use the provided T-
handle wrench through the holes in inner rail to
loosen bearing screw. See Figure 7-17. Turn
eccentric nut (M
5
) until bearing is just contacting
ceiling of rail channel. Do not adjust bearing too
tightly to rail. Tighten bearing screw.
Figure 7-17
12. Adjust front bearing (M
6
, Figure 7-18) in similar
manner, until it just contacts inner rail.
13. If needed, adjust scraper bearings (M
7
, Figure
7-18) at front and back so that scrapers just
contact inner rail channel.
Figure 7-18
14. Check height of horizontal bearing bracket
(Figure 7-19). To make adjustments, loosen nut
(O
1
) and raise or lower bearing to just contact
bottom lip of table. Tighten nut.
Figure 7-19
15. Slide table forward and back the full extent of its
travel. It should slide smoothly without bumps
or thumping noises as it engages the rails.
Make any additional adjustments as needed.
7.7 Angle adjusting rail installation
1. Slide angle adjusting rail (C, Figure 7-20) onto
the two T-nuts (C
1
).
2. Position rail so that approximately 4-inches
extends past front of table. (This position can be
further adjusted later.)
3. Place straight edge over table and angle
adjusting rail at front and back, to ensure that
rail is level with table along its entire length. See
Figure 7-21.
4. Raise or lower rail as needed until level, then
tighten the screws on both T-nuts to secure
position.
Figure 7-20
Figure 7-21
5. Insert T-nut with locking handle (R/S, Figure 7-
22) into bottom channel of angle adjusting rail.
Tighten locking handle to secure push bar (C
2
).