Powermatic 1792000K, Инструкция и каталог запасных частей

Страница: 6 / 44

6
Introduction
This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and
maintenance procedures for a Powermatic Model PM2000 Table Saw. This manual contains instructions
on installation, safety precautions, general operating procedures, maintenance instructions and parts
breakdown. This machine has been designed and constructed to provide years of trouble free operation if
used in accordance with instructions set forth in this manual. If there are any questions or comments,
please contact either your local supplier or Walter Meier. Walter Meier can also be reached at our web
site: www.wmhtoolgroup.com.
Specifications
Model number .............................................................................................................................. PM2000
Stock Number
3HP, 230V, 60Hz, 1 Phase, 3600 RPM, TEFC .........................................................................1791999
5HP, 230V, 60Hz, 1 Phase, 3600 RPM, TEFC .........................................................................1791998
5HP, Prewired 230V (for 460V see
Note below), 60Hz, 3 Phase, 3600 RPM, TEFC.................1791997
Table size with standard extensions (L x W/in.) ......................................................................... 42 x 30 1/2
Table size without extensions (L x W/in.) .................................................................................. 22 x 30 1/2
Arbor diameter (in.) ............................................................................................................................... 5/8
Saw blade diameter (in.) ........................................................................................................................ 10
Arbor speed (RPM) ............................................................................................................................ 4300
Left tilt range ..................................................................................................................................... 0–45
Maximum depth of cut (in.) ..........................................................3-1/8 at 90-degrees; 2-1/8 at 45-degrees
Maximum diameter of dado (in.)............................................................................................................... 8
Maximum width of dado cut (in.) ....................................................................................................... 13/16
Drive system ............................................................................................................................ Poly-V Belt
Table height to floor (in.) .................................................................................................................. 34-1/2
Dust port diameter (in.) ............................................................................................................................ 4
Caster elevation (in.)............................................................................................................................. 1/8
Shipping weight (saw only) ........................................................... All Models: Net: 540 lbs, Gross: 604 lbs
Note: For 460V operation, magnetic switch (Part No. PM2000-293E) must be purchased separately and
installed. A qualified electrician is recommended.
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier reserves the right to change specifications at any time and without
prior notice, without incurring obligations.
Read and understand the entire contents of this manual before attempting
assembly or operation! Failure to comply may cause serious injury