Drilling guidelines
4.
Drilling guidelines
1.
Step 1 - mark the spots locations on the table
1.
Make sure it’s according to the quantity requested per table
2.
Mark all the locations
before
drilling and make sure all are aligned vertically and
horizontally
3.
Make sure not to mark a place above a leg or a bracket
4.
When marking the drill locations use painters tape, this will prevent surface
chipping while drilling see Figure 1: Marking the Charging Spots location
Figure 1: Marking the Charging Spots location
Figure 2: Drilling over a bracket
2.
Step 2 - Verify again table thickness
The charging spot can be installed in tables between ¾” to 3” (19.05 mm – 76.2 mm)