www.oneremote.dk
6
INSTALLATION
The OneRemote PowerLink Switch is easily installed.
1.
Connect the speakers with PowerLink cable(s).
Not included.
2.
Connect the two sound sources with appropriate cables.
Not included.
3.
Connect the mains adaptor.
CABLE QUALITY
Make sure to use good quality PowerLink cables, preferably double-shielded types, especially if
long cables are used. Do not use un-shielded cables for any connection.
PowerLink MKII with 4-wire mounted is not recommended.
Badly or non-screened cables pick up noise from the surroundings.
AUX SOURCE NOISE REDUCTION
The AUX input can connect to any audio source. A regulated line output from a
preamplifier is one type of signal, a headphone output on a TV is another type.
Use the two NR DIP switches on the PowerLink Adaptor to match the source,
and thereby reduce noise. The switches must both be either up or down. Use
the position with the best result.
If noise disappears when pulling out the AUX plug, the noise is either being
picked up from cables, or the quality of the source may be poor.
In rare setups a humming low pitched noise can appear due to problems with ground planes. If
this occurs, an audio transformer can solve the problem.
AUX SOUND LEVEL
Use the two adjustments to align the level of the PowerLink and the AUX
source.
This adjustment also sets the maximum volume for the AUX source.
