Powerjet PJG-2002B, Руководство оператора

Страница: 4 / 15

PJG SERIES PRESSURE WASHER
OPERATOR’S MANUAL
SHUT DOWN PROCEDURES
1. Rinse all lines (and injector) with clean water, to
remove any soap residue.
2. Turn engine off.
3. Turn off water supply.
4. Open spray gun to relieve remaining pressure.
5. Remove water supply hose.
6. In freezing conditions, disconnect water supply
and open shut off gun to allow water to drain, then
turn off motor.
CAUTION: Do not allow pump to run longer than 5
minutes without water. Disconnect all hoses to
allow water to drain.
CAUTION: With machine off, open gun to release
pressure before removing discharge hose.
HOW TO USE THE CHEMICAL
INJECTOR
WARNING: Some chemicals or
detergents may be harmful if
inhaled or ingested, causing
severe nausea, fainting or
poisoning. The harmful
elements may cause property
damage or severe injury.
1. Place chemical pick-up tube into container of
chemical solution.
2. Install the brass soap nozzle provided with the
unit into the quick coupler of the wand.
3. Adjust chemical injector knob to desired ratio
(water chemical ratio is approximately 15 to 1)
4. When you finish washing, rinse by simply
releasing the trigger on the spray gun, removing the
soap nozzle and replace the pressure nozzle back into
quick coupler
NOTE: The chemical injector will not siphon with
the high pressure nozzle at the end of the wand.
5. For clean-up, place chemical pick-up tube into
container of clear water and follow steps listed above
to prevent chemical deposits from damaging the
injector.