Powerhorse 49438, Руководство пользователя

Страница: 9 / 17

Page 9 of 17
Operating Instructions
1. After before-use inspections, place the cleaner at the edge of the surface to clean.
2. Bring a pressure washer to the area.
Do not use the surface cleaner with a pressure washer that has a fluid delivery greater than 3600 PSI,
6 GPM, and 200º F. Fluid delivery above these parameters may overload the cleaner and cause
damage to components and possibly personal injury.
3. Connect the surface cleaner hose at the handle to the pressure washer hose.
4. With one hand on the surface cleaner handle, start the pressure washer.
Do not tilt the surface cleaner up off any of the casters while in use. The operating pressure is very
high and wildly spraying fluid can easily cause personal injury and property damage.
5. Slowly walk behind the surface cleaner watching for good cleaning action.
6. When cleaning is complete, stop the pressure washer. When fluid pressure is released through
the sprayer nozzles, disconnect it from the surface cleaner.
After Each Use
Perform the following inspections after each use to clean the cleaner and ready it for the next use.
•
Clean out any dirt or foreign material from under the housing and the casters. If necessary, use a
cloth or sponge to wash the surface cleaner and rinse it with tap water.
•
Check for loose parts and any damage.