Powerhorse 45749, Руководство пользователя

Страница: 10 / 17

How to Replace the Spark Plug
Check the gap (A) with a wire gauge (B). If necessary, reset the gap. Install and tighten the spark plug to the
recommended torque. For gap setting or torque, see the Specifications section.
Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was
originally equipped with a resistor spark plug, use the same type for replacement.
Inspect Muffler and Spark Arrester
WARNING
Running engines produce heat. Engine parts, especially muffler, become
extremely hot.
Severe thermal burns can occur on contact.
Combustible debris, such as leaves, grass, brush, etc. can catch fire.
.Allow muffler, engine cylinder and fins to cool before touching.
· Remove accumulated debris from muffler area and cylinder area.
WARNING:
Replacement parts must be the same and installed in the same position as the original parts or
fire could result.
How to Service the Air Filter (see figure 3)
1. Remove the air cleaner outside cover (A). Be careful to prevent dirt and debris from falling into the air cleaner
assembly.
2. Separate the Air Filter (A) from the Air Filter Housing (B).
3. Inspect the air filter. Clean dirty air filter with warm water and mild soap. Allow air filter to dry thoroughly before
re-installation
4. Install the air filter assembly onto the carburetor and secure with screw.
Note:
Do not use pressurized air or solvents to clean the filter. Pressurized air can damage the filter and solvents
will dissolve the filter.
A
B
C
D
Figure 4
Figure 3
9