Switched Mode Power Supply
Operating manual
PAP3200HV
Perämiehenkatu 6, FIN 24100 Salo, Tel. +358 2 777 290, Fax +358 2 777 2918, [email protected], www.powerfinn.fi
3
Dimensions
Installation
The location must be dry, dust-free and indoors. Equipment must be connected to an earthed mains socket outlet. For
unplugging the unit, make sure the wall socket is near and in an easy access area. The acceptable full power temperature
range is 0
°C…+40°C. The thermal protection will cause the unit to power down at too high an operating temperature. The
power supply is not waterproof. Keep it dry and away from areas with high humidity in order to avoid the risk of electrical
shock and damage to the charger.
Wall mounting
The power supply can be mounted to the wall with the two mounting holes on
both ends of the power supply unit as shown in the figure.
It is recommended that the power supply is mounted vertically on to the wall. It
is suitable for mounting on a concrete or other non-combustible surface only.
Leave at least 10 cm free space at the cooling fan end and at both sides of the
power supply to ensure sufficient ventilation.
When used as a charger, the charging process generates explosive hydrogen
gas. Install the power supply as far away from the battery as possible to
prevent hydrogen gases from entering the charger. Keep the area well
ventilated. Never use an open flame or equipment that produces sparks close
to the power supply and battery.
Charging operation
1.
Ensure that the power supply is switched off and that the environment meets the conditions as described in
the previous section.
2.
Connect the output cables to the load / battery terminals: + cable to the + terminal and
– cable to the –
terminal
3.
Turn the power on by turning the switch to position 1.
4.
During normal power supply operation / charging process, the STATUS LED is continuously orange.
5.
To avoid sparking, turn off the power supply before disconnecting the cables.
