Switched Mode Power Supply
Operating manual
PAP3200HV
Perämiehenkatu 6, FIN 24100 Salo, Tel. +358 2 777 290, Fax +358 2 777 2918, [email protected], www.powerfinn.fi
1
03.Jun.2019
Features:
Wide output range 0…900Vdc
Analog control by an external
0…5Vdc
Power failure alarm output
Master-slave connection
Powerfinn PAP series is a high power, lightweight, advanced power supply using modern switching technology.
All units can be used as a power supply or constant voltage battery charger. The output voltage and output
current can be adjusted from 0 to maximum value by an external 0-5V analog control, with internal adjustment
trimmers or from a serial bus.
Specifications
Input voltage
70…264Vac 1–phase ( 70…230Vac, reduced power )
70…369Vdc
Efficiency
89% at full load, >90% at 50% load ( 230Vac input )
Input current
16A ( max)
Frequency
47
–63Hz
Power factor
>0.98
Inrush current
soft start
Output ripple
<1%rms from maximum output voltage (1MHz bandwidth)
In S and T versions the resolution is defined by an 8-bit A/D converter of a
microcontroller. Measured using nominal output voltage.
Mechanics
Wall mounting, see dimensions p. 3
Connectors
Input
Input power cord
Output
SPT5/2-H-7,5 Phoenix
Enclosure
Aluminum case, IP20
Weight
7.1 kg without cables
Output Grounding
Floating
Ambient temperature range
0°C…+40°C at full load, abs. max. +55°C
Overtemperature protection
Processor controlled on/off
Overcurrent protection
Electrical current limit
Reverse polarity protection
With fuse
Standards
Safety
Class 1
EN 60950-1
LIMITATIONS
Conformity can be limited depending on the end application output control method or unit mechanical structure.
Note: If the
charger’s rated output voltage is higher than 60VDC the charger doesn’t fulfill 1.2.8.7 (Safety Extra Low
Voltage). Standard parts (2.1 Protection against electric shock) must be taken into account in installation.
EN60335-2-29:2004
EN60335-1:2002 +A11:2004 +A1:2004 +A12:2006 +A2:2006
EN50366:2003 +A1:2006
LIMITATIONS
Conformity can be limited depending on the end application output control method or unit mechanical structure.
Note: If the
charger’s rated output voltage is higher than 36V it doesn’t fulfill article 10.101 (“The no-load d.c. output voltage
shall not exceed 42.
4V”).
EMC
Limits EN55022 Class B,
Application must be discussed in detail
