Switched Mode Power Supply
Operating manual
PAP3200
Perämiehenkatu 6, FIN 24100 Salo, Tel. +358 2 777 290, Fax +358 2 777 2918, [email protected], www.powerfinn.fi
3
Input voltage / Output power ( Uout 72V version )
Dimensions
Installation
The
location
must
be
dry,
dust-free
and
indoor.
The
acceptable
full
power
temperature
range
is
–25°C…+40°C. The thermal protection will cause the unit to power down at a too high operating temperature. The power
supply is not waterproof. Keep it dry and away from areas with high humidity in order to avoid the risk for electrical shock and
damages to the charger.
Wall mounting
The power supply can be mounted to the wall with the aid of the two mounting
holes on both ends of the power supply unit as shown in the figure.
The power supply can be installed horizontally or vertically. In horizontal
installation IP21 protection class can not be met.
Leave at least 10 cm free space at the cooling fan end and to the both sides of
the power supply to ensure sufficient ventilation.
When used as a charger, the charging process generates explosive hydrogen
gas. Install power supply as far away from battery as possible to prevent
hydrogen gases going inside the charger Keep the area well ventilated. Never
use an open flame or equipment that produce sparks close to the power supply
and battery.
