PRINTED IN TAIWAN A03-3713353-438
2.
Insert AA and/or AAA batteries.
ALWAYS INSERT THE BATTERIES
FROM LEFT TO RIGHT LEAVING NO EMPTY SLOT
.
For best performance,
group batteries of similar charge and/or type
together
(e.g. 2500mAh AA batteries in slot 1, 2, 3, 4 and 1800mAh
AA batteries in slot 5, 6 and 700mAh AAA batteries in slot 7, 8).
NOTE: Ensure that the batteries are pressed down all the way to
ensure optimal contact.
The figures below show possible configurations for battery placement.
3.
When the battery is correctly inserted, charging will commence for that
slot. The charger is equipped with a four-level battery gauge which
displays the charging progress.
Flashing
Extremely low charge. Typically indicates
abnormal or aged batteries. Conditioning is
recommended.
Flashing
Flashing
Flashing
0-50%
charge
50-80%
charge
80-100%
charge
Charging
completed.
Flashing
Battery fault
Soft Charging Mode
NOTE: Soft Charging is activated for all battery slots simultaneously and
cannot be activated for each individual battery.
1.
Remove all batteries from the charger, if any.
2. Insert
one
battery in the leftmost slot.
3.
Within five seconds, press and hold the “SOFT” button until “Soft
Charging” symbol is displayed on the LCD screen.
4.
Insert the remaining batteries from left to right leaving no empty slot.
5.
Soft Charging mode will remain activated as long as there are batteries
in the charger (even if charging is completed). The charger will reset to
Rapid Charge mode (Soft Charging symbols disappears) when all
batteries are removed.
Conditioning Mode
NOTE: Conditioning is activated for all battery slots simultaneously and
cannot be activated for each individual battery.
1.
Remove all batteries from the charger, if any.
2. Insert
one
battery in the leftmost slot.
3.
Within five seconds, press and hold the “CONDITION” button until
”Condition” symbol is displayed on the LCD screen.
TIP: If Conditioning and Soft Charging is desired simultaneously, insert
the first battery, press the Soft Charging button first followed
immediately by the Conditioning button. THIS CAN TAKE UP TO 35
HOURS TO COMPLETE.
4.
Insert the remaining batteries from left to right leaving no empty slot.
5.
The condition cycle will first apply an initial charge, discharge then
recharge the batteries.
Initial Charging
Discharging
Recharging
It is normal for all symbols to disappear from one or more slots toward
the end of discharge. This indicates that discharging is nearly
completed and recharging will commence soon.
Manufactured By:
MAHA ENERGY CORP.
1647 Yeager Ave. La Verne, CA 91750
Tel: 1-800-376-9992, 1-909-392-1568
http://www.mahaenergy.com/
Copyrighted ® 1998-2006 Maha Energy Corp.
