Powercraft
5
BEFORE OPERATING
Before you switch on the hot air gun you have to search
for the right adapter for the mouthpiece and assemble it
on the mouthpiece if it is still cold.
IMPORTANT: Replace the mouthpiece only:
-
with a stationary engine;
-
when the appliance is disconnected;
-
when the mouthpiece is cold.
OPERATION
-
Check if the mains switch is on position
“0”
before you connect the apparatus;
-
Keep the power voltage always away from the hot air
stream and the mouthpiece;
-
Put the mains switch in position
“1” or “II”
to let
your hot air gun operate:
-
“1”
= 608 °F, air stream 500 l/min.;
-
“0”
= off;
-
“2”
= 1076°F, air stream 650 l/min.
Tip:
If you want to get the best result, test all appliances
on a little part of the workpiece.
MAINTENANCE
Always disconnect the apparatus before carrying
out inspection or cleaning. Never use water or other
liquids to clean the electrical parts of the hot air gun.
-
Never use easy inflammable liquids for cleaning the
hot air gun, especially for the mouthpiece.
-
Regular maintenance of your hot air gun prevents
unnecessary problems. Keep the ventilation slots of
the hot air gun clean to prevent overheating.
TROUBLESHOOTING
In case the hot air gun does not work well, we give you
subjoined some possible causes and their solutions.
1. The engine gets overheated.
The ventilation slots of the hot air gun are dirty.
- Clean the ventilation slots.
2. The hot air gun does not start when it is
switched on.
Interruption in the electrical circuit.
- Check the mains lead and the mains plug.
The switch is defective.
Pull the mains lead out of the wall socket, because
there is a chance of fire risk ! Have the hot air gun
repaired at your local dealer.
3. The engine does not work, but it does heat.
Interruption in the electrical circuit.
Pull the mains lead out of the wall socket, because
there is a chance of fire risk ! Have the hot air gun
repaired at your local dealer.
C
l
E
l
■
DECLARATION OF CONFORMITY
(UK)
We declare under our sole responsibility that this
product is in conformity with the following
standards or standardized documents
EN60335-2-45, EN60335-1,
EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-3
in accordance with the regulations:
73/23/EEC
89/336/EEC
from 01-02-2003
Oststrasse 11 - 13
50996 KÖLN BRD
E. Kok
Quality department
4
Powercraft
