PowerBass XPRO-10, Инструкция по применению, Страница: 9 / 16

• Check to see if there is enough clearance behind the mounting surface before drilling holes or install-
ing screws for proper speaker ventilation.
• Also make sure there’s enough front clearance for speaker cone excursion. Failure to do this could
cause the cone to vibrate against any obstructing object damaging the speaker.
• Use a utility knife to trim away fabric from the speaker mounting hole location before drilling. It is
hard to get a good seal if you have both the carpet & subwoofer gasket between the speaker and
the enclosure.
• When running speaker wires through sheet metal, be sure to use grommets to properly insulate the
wires from metal edges.
DOOR MOUNTING
When checking for possible speaker locations in the doors, check the operation of the window and all
assemblies. There is also a stabilizer stop bar in between the door and the door jam. This bar prevents the
door from opening too far.
REAR DECK MOUNTING
In rear deck installations, check the operation of the trunk suspension springs or tension bars. These tension
bars move in the opening and closing of the trunk. You cannot be too cautious during this part of the instal-
lation. In addition do not locate the speakers too close to the back of the rear deck. Installing the far screws
may not be possible without removing the rear window.
Fig. 3 Mounting Surface must be flat
9