PREPARING FOR INSTALLTION
NOTE: The tools listed below may be required for basic installation.
•
An electric drill with bits
•
Saber, circular and jig saw
•
Phillips-head and standard screwdrivers
•
Wire strippers
•
Crimping tool and needle-nose pliers
•
Silicone sealant (for enclosures), closed cell weather-stripping (for the speakers)
INSTALLATION PRECAUTIONS
NOTE: Proceed only if you are a qualified installer otherwise; let your dealer do it.
•
Always wear protective eyewear when using tools.
•
Turn off all stereo and other electrical devices before you begin.
•
Disconnect the (-) negative lead from your vehicle’s battery.
•
Keep the speakers in the package until final installation, and always rest it with the cone facing up.
Never use force when installing a speaker.
•
Locate all fuel lines, brake lines, oil lines, and electrical cables when planning your installation.
•
Check to see if there is enough clearance behind the mounting surface before drilling holes or install-
ing screws for proper speaker ventilation.
•
Also make sure there’s enough front clearance for speaker cone excursion. Failure to do this could
cause the cone to vibrate against any obstructing object.
•
Use a utility knife to trim away fabric from the speaker mounting hole location before drilling. It is
hard to get a good seal if you have both the carpet & subwoofer gasket between the speaker and
the enclosure.
•
When running speaker wires through sheet metal, be sure to use grommets to properly insulate the
wires from metal edges.
