TECHNICAL FEATURES
•
Mono Block Amplifier for Full Range or Subwoofer Only Applications
•
MOSFET Power Supplies for High Power Output and Unprecedented Stability into Low Impedance
Loads
•
Soft Delay Remote Turn On/Off Circuit to Eliminating Pops and Clicks
•
Built-in Fully Adjustable Electronic Low Pass (LPF) Crossover Network
•
Built-in Fully Adjustable Bass Equalization
•
Self Diagnostic Protection Circuit with LED Status Indicator for Impedance Over-load, Speaker Short
Circuit, Thermal Overheating, and DC Output.
•
2-ohm Stable Operation (Minimum)
•
Variable Gain Control
•
Pass Thru Line Output Jacks
•
Remote Level Control (Included)
INSTALLATION EXPERIENCE
Installation of PowerBass mobile amplifiers requires detailed knowledge of electronics wiring and proper
speaker impedance. We strongly recommend installation by an authorized PowerBass dealer. This Own-
ers Manual only provides general installation and operation instructions. If you have any reservations
about your installation skills, please contact your local PowerBass dealer for assistance.
IMPORTANT : This amplifier is designed for operation in vehicles with 12-volt Negative ground
electrical systems only.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
•
An electric drill with bits
•
Philips head and standard screwdrivers
•
Wire strippers
•
Crimping tool
•
VOM (electronic volt ohm meter)
•
Heat shrink tubing and heat gun
•
Soldering iron
•
Electronic (Rosen Core not Acid Core) Solder
3
