PowerBass ASA 1000.1Dx, Руководство пользователя

Страница: 18 / 24

4. DUAL LINK AMP TO AMP BRIDGED CONNECTION
Bridging two amplifiers ( of same model) can be done via the BRIDGED switch and wiring the two amplifiers
as follows:
Fig.13 Dual Link minimum 2 ohm load
SPEAKER FUSE POWER
LINE
OUT LINE
IN
LEVEL PHASE
MIN MAX
POWER
STATUS
R
L
LPF
50Hz 150Hz
SUB
SONIC
15Hz 50Hz
BASS
BOOST
0 +18dB
0 180
BRIDGED
BRIDGED
CONNECTION
REMOTE
MASTER SLAVE
BATT
+
REM GND
SPEAKER FUSE POWER
BATT
+
REM GND
LINE
OUT LINE
IN
LEVEL PHASE
MIN MAX
POWER
STATUS
R
L
LPF
50Hz 150Hz
SUB
SONIC
15Hz 50Hz
BASS
BOOST
0 +18dB
0 180
BRIDGED
BRIDGED
CONNECTION
REMOTE
MASTER SLAVE
HEAD UNIT
MASTER AMP SIDE PANEL
SLAVE AMP SIDE PANEL
MASTER AMP SIDE PANEL
SLAVE AMP SIDE PANEL
2 – 4 ohm
SUBWOOFER
SWITCH POSITION
BRIDGED
MASTER SLAVE
SWITCH POSITION
BRIDGED
MASTER SLAVE
RJ45 Cable
NOTE: SPEAKER CONNECTION FOR BRIDGING TWO AMPS
• The mono woofer must be connected between the speaker (+) terminals of the two amplifiers and use
at least #12 gauge speaker wiring.
• Install a #12 gauge wire link between the speaker (–) terminals of the two amplifiers. If this is not done,
the system will not function properly, and damage to the amplifiers may result.
• Total impedance of speakers must be over 2-ohms. If the impedance drops under 2-ohms, critical dam-
age to the amplifier will occur.