Power APW3200KH, Руководство пользователя и инструкции по эксплуатации

Страница: 24 / 76

1.
2. Fill crankcase with required amount of Place product on flat level surface.
fresh clean engine oil (0.6 Quart), using
table below to determine the correct
viscosity.
3. Replace dipstick in hole, but don’t thread
in. Remove the dipstick to confirm oil
level. Replace dipstick and tighten
to finger tight, DO NOT Use a tool to
tighten. Over tightening will break or
damage the dipstick threads.
NOTICE: All oil should meet minimum
American Petroleum Institute (API) Service
Class SJ, SL or better. Use no special
additives. Select the oil’s Viscosity grade
according to the expected operating
temperature.
(See chart below)
• Above 40° F, use 1 0W-30
• Between 40° F and 10°F, use 1 0W-30
• Below 10°F, use synthetic 5W-30
5. Remove the drain plug and, if possible,
tilt the crankcase slightly to help drain
the oil out into the pan. Recycle used oil.
6. Replace the drain plug and tighten it.
2. Adding Engine Oil
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
MAINTENANCE 22
NOTICE: Do not run the engine with too
little oil. If equipped with Low Oil Shutdown,
the engine will not start with low or no
engine oil.
Spark Plug Maintenance
1. Disconnect spark plug cap from end of
plug. Clean out debris from around spark
plug.
2. Using a spark plug wrench, remove the
spark plug.
3. Inspect the spark plug:
• If the electrode is oily, clean it using a
clean, dry rag.
• If the electrode has deposits on it, polish
it using emery paper.
• If the white insulator is cracked or
chipped, the spark plug needs to be
replaced.
RECOMMENDED SPARK PLUGS
CHAMPION RA6HC
NGK DPCR63
NOTICE: Using an incorrect spark plug
may damage the engine. DO NOT over
tighten spark plug, or engine threads can
be damaged.
4. When installing a new spark plug, adjust
the plug’s gap to the specification on the
Specifications chart. Do not pry against
the electrode, the spark plug can be
damaged.
• Install the new spark plug or the cleaned
spark plug into the engine.
• Gasket-style - Finger-tighten until the
gasket contacts the cylinder head, then
tighten about 1/2-2/3 turn more.
5. Non-gasket-style - Finger-tighten until
the plug contacts the cylinder head, then
tighten about 1/16 turn more.
6. Reattach the spark plug cap securely.
Spark
Plug
Cap