STEP 2
Attach 2 blunt rods with connectors* to complete corner posts.
Attach screw-tight insulators at desired height.
Tighten securely. Height will be determined by the animals you are
putting in the corral.
Drive tie-down stake at corners with drive cap.
Tie cord to stake and hammer stake into ground. At the other
end of the cord, make a loop and knot and loop over top of posts as
shown. See Figure B.
A round corral may not need any tie-down stakes. See Step 4 on
Page 6 for an illustration.
POST MOUNTING METHOD
The Power Wizard PW350B will be mounted to the metal ground
rod (energizer hanger) included with this kit. Hang the energizer
on the post using the channel located on the back left of the
energizer.
Loosen the Post Clamp/Ground Terminal Knob (A) to allow the
post to slide into place. Follow the guide to the right for
specific post location.
Tighten the Ground Terminal Knob (A) to clamp the PW350B to
the post.
1
1
2
2
3
3
4
4
1/2 inch (10-12mm)
furnished ground rod
goes in this channel
4
13
Figure B.
Cord looped
over stake.
Figure C.
Posts
connected by
ferrules
(connectors).
Figure H. Energizer attached
to ground rod.
*NOTE:
Twist rods
to fit into
connectors
properly.
