Assembly
14
Steering
Wheel
Notch
Steering Wheel Cap
• Align the notch in the side of the steering wheel cap
with the tab in the center of the steering wheel. Fit the
steering wheel cap into the steering wheel.
• Insert two #8 -18 x 1" screws into the steering wheel
cap and tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Position the steering wheel upright, so that the spokes
form a "Y".
• Fit the steering wheel onto the steering column. Make
sure the neck of the steering wheel fits into the hole in
the dash.
• Fit a cap nut onto the end of the steering column.
• Tap the cap nut with a hammer to secure it on the
end of the steering column.
Hint:
You may want the help of another adult to support
the other end of the steering column while you tap the
cap nut with the hammer.
Steering
Wheel
Steering
Column
“UP”
Cap
Nut
Dash View
Dash View
17
18
Upper
Steering
Linkage
Front Axle
Assembly
Hole
Curved End
of Steering
Column
• From the underside of the vehicle body, fit the curved
end of the steering column through the hole in the upper
steering linkage.
Hint:
You may need to rotate the steering column to fit it
into the hole.
Bottom View
Steering
Column
Cap Nut
• Fit a cap nut on the end of the steering column.
• Tap the cap nut with a hammer to secure it on the end
of the steering column.
Hint:
You may want the help of another adult to support
the steering column while you tap the cap nut with
the hammer.
• Position the vehicle body upright.
Bottom View
16
15
75597pr-0920.qrk 8/1/01 4:56 PM Page 14
