Problem
Possible Cause
Solution
Vehicle does not run
Undercharged batteries
Charge the batteries. New batteries should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the batteries for
at least 14 hours after each use. Never charge the batteries
longer than 30 hours.
Check all connectors. Make sure the battery connectors are
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is “ON”.
Charger is not working
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels
®
authorized
service center. They can test your charger for you.
Tripped thermal fuse
Each Power Wheels
®
6 volt battery has a built-in thermal
fuse. A thermal fuse may "trip" and shut down operation of
the vehicle if the vehicle is overloaded or the driving
conditions too severe. The fuse will automatically reset itself
after approximately 25 seconds, allowing the vehicle to
resume normal operation. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the
65 lbs maximum weight capacity or by towing anything
behind the vehicle. Avoid severe driving conditions, such as
driving up very steep hills or running into fixed objects,
which can cause the wheels to stop spinning while power
is still being supplied to the motors. If a thermal fuse
continually trips, contact your local Power Wheels
®
authorized service center.
Loose wire or loose connectors
Check all wires and connectors. Make sure the battery
connectors are tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
Dead batteries
If your batteries are old or if you have not followed Battery
Care instructions, your batteries may be dead. If you are
unsure whether or not the batteries are dead, you can have
them tested at your local Power Wheels
®
authorized
service center.
Electrical switch damage
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels
®
authorized service center for diagnosis and repair.
Motor damage
Contact your local Power Wheels
®
authorized service center
for diagnosis and repair.
Vehicle was running but
Loose wire or loose connectors
Check all wires and connectors. Make sure the battery
suddenly stopped
connectors are tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
IMPORTANT!
If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact Power Wheels
®
Consumer Affairs,
toll-free at
1-800-348-0751
between 8 AM and 5 PM (EST) Monday through Friday. Or, contact
your local Power Wheels
®
authorized service center. For the location nearest you, please refer to
the Authorized Service Center list beginning on page 29.
26
Problems and Solutions Guide
N
