Power Sound Audio T-18, Руководство пользователя

Страница: 10 / 14

11
POWER INLET
The powerCon AC connector is a locking three conductor AC connector.
The connector must be locked into place for power to fl ow.
DO NOT dis-
connect the powerCon AC CONNECTOR while the POWER SWITCH
is in the ON position.
POWER OUTLET
The powerCon AC connector is a locking three conductor AC connector.
DO NOT USE THIS OUTLET. PLEASE KEEP THE PLASTIC PLUG
INSTALLED.
VOLUME CONTROL
The VOLUME control is used to adjust the output level of the subwoofer.
This control should be set to a similar level as your loudspeakers in
order to achieve a properly blended sound stage. Proper calibration
procedures should be used to adjust the level of your subwoofer.
= minimum gain (no sound)
0 = maximum gain
LOOPING OUTPUT
The LOOPING OUTPUT consists of a three pole male XLR connec-
tor. This output is typically used to connect another subwoofer to the
system.
POWER SWITCH
The POWER SWITCH is a basic on/off rocker switch.
ON = Turns on the subwoofer and leaves it on.
INPUT
The subwoofer INPUT consist of a three pole female XLR connector. If
your equipment does not have an XLR subwoofer output, please use
the included XLR to RCA adapter cable and, if necessary, the RCA
barrel connector. Push on the steel latch lock to remove the XLR cable
from the amp.
MUTE
The MUTE button disables all sound from the subwoofer.
IN = Mute disabled
Out = Mute enabled
PGM SEL
The PGR SEL button allows you to select between two built-in EQ
curves. The two EQ curves were designed to optimize the subwoofer’s
performance in large to very large rooms.
YOU MUST TURN THE
POWER OFF BEFORE PRESSING THE PGM SEL BUTTON.
IN = Room size < 5000 cubic feet
OUT = Room size > 5000 cubic feet
AMPLIFIER CONNECTIONS AND CONTROLS
1
8
7
4
6
3
5
2