Power smart DB7001, Руководство пользователя

Страница: 16 / 19

Auger Control Cable Adjustment
The auger cable is located on the left side(when standing behind the snow blower) and is made
up of an upper and lower cable connected by an adjustment plate. The adjustment plate is located
in-line with the cable below the control handle and is covered by a black plastic slip cover. The
adjustment plate is used to adjust auger belt tension.
5
1
2
3
4
1- Upper Auger Cable (Always in upper center hole)
2- Adjustment Plate
3- Lower Auger Cable
4- Adjustment Plate Lower Cable Opening
5- Slip Cover
1.Stop the engine.
2.Disconnect the upper cable from the auger
control handle.
3. Slide up the slip cover to access the
adjustment plate.
1
2
3
4. Adjustment is made by changing the position
of the lower cable in the adjustment plate
holes(1 to9).
Only move the lower cable diagonally
one hole at a time from its original position.
Note: The upper cable end must be in the
upper single center hole of the adjustment
plate. Do not change the position of the upper
cable.
5. Connect the upper cable to the control handle.
6. Start the engine and engage the auger to test
the operation of the auger.
Test the snow thrower to see if there is a noticeable difference.
If after the adjustment to the control cable the auger still hesitates
when rotating, the belt may need to be replaced, please call our service
department for assistance.
16
1
2
3
4
5
6
7
8
9
L e s s Te n s io n
U p p e r
C a b le
L o w e r
C a b le
M o re Te n s io n