GEN7500DF 7500 Surge Watt / 6000 Running Watt Portable Dual Fuel LPG Liquid Propane Gas & Gasoline Electric Start Generator Manual
33
PORTABILITY KIT INSTALLATION
The manufacturer recommends that you properly install the Portability Kit
when using your generator. Installing the Portability Kit is not required
for the GEN7500DF to operate, but is included with the generator purchase.
1. Locate the handle-mounting bracket on the generator frame. (Located on the top right side when looking at the control panel of the generator,
Figure 1). Attached the handle by placing the handle around the outside of the handle-mounting bracket, and aligning the bottom set of holes. Insert
a bolt (M8*50) through home on the frame and the handle-mounting bracket, and secure with a nut (M8) and washer.
Insert the bolt pin (M8, which links with cable) into upper hole on the frame when the handle when moving the generator (Figure 2). To lower the
handle remove the pin, lower the handle, and replace the bolt pin (Figure 3).
Install the wheel axle into frame (Figure 4), fix with a washer
(φ27*φ16.5*2) and pin (φ3.2*40). Tighten and secure both wheels. (Figure 5)
Install the stabilizing bar (Figure 6) by inserting the bolts (M8x20) through the feet on the stabilizing bar and the generator frame.
Figure 5
Figure 1
Figure 2
Figure 3
Figure 6
