Power-Pole micro anchor, Руководство по установке

Страница: 8 / 10

F
F
Programming the MICRO Driver Unit
Programming Dual MICRO Driver Units
Pairing Dual MICRO Driver Units
to a Single Wireless Controller
The MICRO Driver comes programed as a single unit. For
proper performance do not program a single unit as port or
starboard. If you have a single unit proceed to the Owners
Guide for calibration instructions prior to using the unit.
When installing dual units, you can program a single Dash Switch
and/or Key-Fob remote to control both driver units by following the
steps below.
1. Determine which unit is paired with the controller by pressing the
UP or DOWN button.
2. Press and hold the program/pair button on the other unit for three
seconds until the LED turns green.
3. Press and hold the UP or DOWN button on the controller until
both units respond.
1. With both MICRO Driver Unit locations identifi ed,
begin with the starboard side unit. Press and hold the
“Program” button for 6 seconds until the LED turns red.
2. Press the UP button to set as the starboard side unit.
The LED will fl ash red one time indicating that the
programming has been completed successfully. Now
press and release the program button to save and exit.
The LED will fl ash red one time.
3. On the port side, repeat Step 1 to enter programming
mode. Next, press the DOWN button to set as the port
side unit. The LED will fl ash red twice indicating that the
programming has been completed successfully. Now
press and release the program button to save and exit.
The LED will fl ash red twice.
s
Programming LED
Program Button
NOTE: You should make sure your Dash Switch is paired with
your single or multiple driver units before installation.
Mark and drill a pilot hole with 1/8” drill bit to fasten switch using
the (2) screws (F) supplied
(do not over tighten). Or you may choose
to use adhesive strip (P) also supplied.
Installing the Dash Switch