Operating Instructions
The new Advanced Key Fob Remote will react to match the angle or
attitude that you hold the fob. While holding the fob in the desired
speed position, press and hold for Manual Deploy or Retract and
double click for Auto Up or Down.
Using SPEED control
Power-Pole DOWN – While holding the Key Fob at desired position,
press and hold button for Manual Control or double click for
Auto
Mode.
Angle the fob slightly down = DOWN SLOWLY
Continue down angle = DOWN MEDIUM
Steep down angle
= DOWN FAST
Power-Pole UP – While holding the Key Fob at desired position, press
and hold button for Manual Control or double click for
Auto Mode.
Angle the fob slightly up = UP SLOWLY
Continue up angle
= UP MEDIUM
Steep up angle
= UP FAST
Power-Pole DOWN
SLOW
MEDIUM
FAST
Power-Pole UP
SLOW
MEDIUM
FAST
Operating Instructions
DUAL Power-Pole operation
The Advanced Key Fob Remote provides total flexibility and more
control when operating DUAL Power-Pole shallow water anchors.
To operate
BOTH
Power-Pole anchors at the same time:
1. Hold the fob level, press the button and BOTH anchors will
operate together.
To operate the
LEFT
Power-Pole individually:
1. Rotate the fob to the LEFT, the fob will operate the left Power-Pole
independently.
To operate the
RIGHT
Power-Pole individually:
1. Rotate the fob to the RIGHT, the fob will operate the right Power-
Pole independently.
BOTH ANCHORS
HOLD THE FOB LEVEL
LEFT OR RIGHT ANCHOR
ROTATE
LEFT
OR
RIGHT
FCC Part 15.19 Warning Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
FCC Part 15.21 Warning Statement
NOTE: THE
GRANTEE
IS NOT RESPONSIBLE FOR ANY CHANGES OR
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
IC RSS-GEN, Sec 7.1.3 Warning Statement
ENGLISH: This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of
the device.
FRENCH: Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
Changing the Battery
1.
Ensure the surrounding area is as dry as
possible to avoid any moisture intrusion.
2.
Use a small slotted screwdriver to
remove the top cover for the remote
control key fob.
Fig. 1
3.
Remove the rubber switch membrane
and the board from the bottom cover.
4.
Remove the battery from the holder on
the front of the board and replace with
any CR2032 3V Lithium Coin Battery.
5.
Place the board and rubber switch
membrane back into the bottom cover
and ensure that the rubber switch
membrane is seated properly prior to
installing the top cover.
Figure 1
