Hydraulic Pump
Unit (HPU)
C-Monster 2.0 Controllers
LED
DOWN button
PROGRAM button
UP button
C-Monster 2.0 Controllers
PAIRING INSTRUCTIONS
(All Controllers)
STEP 1:
Press and hold the
PROGRAM
button on top of the unit
for 3 seconds (
LED
will turn
GREEN
/
HPU
will beep).
STEP 2:
Press the
UP or DOWN
button on controller for one
second. When Paired, the
GREEN
LED
will turn off
then flash steadily (
HPU
will also beep).
Pairing Dual Power-Poles:
Repeat steps 1-2 to pair remote
to the other pump. Both pumps
can be programmed to a single
controller.
NOTE:
The first time a remote is paired with a recently updated pump it may perform a firmware
update. Remote will blink for 1 minute. Do not interrupt power to pump or remote during
this process. Blinking will stop when update is finished.
INSTALLATION INSTRUCTIONS
(Dash and Foot Switches only)
STEP 1:
Place switch flush in desired location and drill holes with a 1/8” drill bit/electric drill. Use
Switch holes as guide.
STEP 2:
Fasten switches using the supplied
screws
and
Phillips-Head Screwdriver
.
NOTES:
•
Switches must be mounted on flat surface.
•
Do not overtighten screws.
•
Dash Switch
may be installed with screws
or
adhesive strip.
Foot Switch Install
Dash Switch Install
Need help? Contact our Technical Support Team at
1 + 813.689.9932 Option 2
OPERATING INSTRUCTIONS
(All Controllers)
•
Press and hold the
UP/DOWN
button on any controller to raise/lower the
Power-Pole Anchor.
Auto Mode:
•
Double tap the
UP/DOWN
button on any
controller.
•
Can be changed to single tap via the
C-Monster app.
Speed Control
(Dash switch
Only
)
•
Press the
SPEED
button on the switch to
toggle through the 3 speed settings (slow,
medium, fast).
•
All Power-Pole Anchors are programmed
to 70% speed. Maximum speed can be
changed in the C-Monster App.
Dual Operation
•
Press the
DIRECTIONAL
button on Dash
Switch to toggle through the three settings (port, starboard, or simultaneous control).
•
Only Dash Switch can operate port/starboard anchors seperately.
Fittings
Facing
SPEED
BUTTON
DIRECTIONAL
BUTTON
Battery Replacement
(Foot Switch)
IMPORTANT:
Make sure battery replacement is done in a dry location.
STEP 1:
Remove screws using a Phillips-Head screwdriver.
STEP 2:
Remove
Foot Switch Cover
using a Flat-Tip Screwdriver.
FIG. 1
STEP 3:
Remove
Switch Membrane
and
Circuit Board
from the
base
FIG. 2
STEP 4:
Remove battery from holder on back of circuit board and replace with a CR2032 3v Lithium
Coin Battery.
STEP 5:
Reassemble Foot Switch. Make sure black caps click when pressed. If caps don’t click, rotate
board 1/4 turn and reinstall.
FIG. 3 & 4
Switch Membrane
Figure 4
Need help? Contact our Technical Support Team at
1 + 813.689.9932 Option 2
Switch Membrane
Circuit Board
Figure 2
Base
Circuit Board
CLICK
Figure 3
Figure 1
Foot Switch Cover
